
Control Block Description
ADDvantage-32 PLUS
4-18
4.13 BIT CONVERT
The Bit Convert block converts 4 input bits into decimal numbers. The output changes
only when the ENABLE bit is high. This block can also be used as the X_IN value of a
Table block enabling 16 separate setpoints.
FIGURE 4-13. BIT CONVERT BLOCK
1. Inputs
INPA: Bit
INPB: Bit
INPC: Bit
INPD: Bit
ENABLE: Bit
2. Outputs
OUT: Analog
3. Implementation
OUT latches only when the ENABLE input is low. OUT defaults to 0 on powerup.
When the ENABLE bit is high, refer to the following table to determine the value of
OUT.
Comentarios a estos manuales