Digital Acoustics ESBx-110 Especificaciones descargar pdf (Pagina 306)

Maintenance and Troubleshooting

ADDvantage-32 PLUS ● AC to DC Power Converter

7-8

TABLE 7-2. POWERUP MESSAGES (cont.)

FAULT MESSAGE PROBLEM SOLUTION

-------WARNING-------

CONFIG P/N DOES NOT

MATCH HARDWARE ID

UP key to continue

The drive part number

in DRIVE CONFIG

(Y000: DRIVE PN) is

incorrect for the drive

hardware.

a. Insure that Y000 is correct and

matches the part number of the

drive.

b. Replace the microprocessor board

c. Replace the bridge interface board.

d. Replace the ribbon cable between

the microprocessor board and the

bridge interface board

-------WARNING-------

FAILURE TO TRANSFER

CAL and CONFIG

cycle power to reset

Failure to transfer

necessary calibration

and configuration data

between processors

a. Cycle power to the drive.

b. Replace microprocessor board.

-------STATUS-------

ATTEMPTING

TO LOCK THE PLL

TO THE AC LINE

Status message

indicating drive has not

been able to synchronize

to the AC line.

If good AC power is applied to the

drive and the status message persists:

a. Replace the microprocessor board

b. Replace the bridge interface board

c. Replace the ribbon cable between

the bridge interface and

microprocessor boards.

By holding down the UP, DOWN,

LEFT and RIGHT keys at the same

time, the drive will bypass the PLL

LOCK. The drive will not gate any

SCR’s while in the bypass mode.

-------STATUS-------

ATTEMPTING TO

BRING UP THE FIELD

Status message

indicating that the drive

is starting the field.

Status indication only

-------WARNING-------

USB INITIALIZATION

FAILED

UP key to continue

Drive unable to

initialize the USB

subsystem.

a. Cycle power to drive

b. Replace microprocessor board

Note that by pressing the UP key the

drive will complete initialization. No

USB functions will be successful if the

initialization failed.

1 2 ... 301 302 303 304 305 306 307 308 309 310 311 ... 465 466

Comentarios a estos manuales

Sin comentarios