Digital Acoustics ESBx-110 Especificaciones descargar pdf (Pagina 364)

IEEE 802.3 Ethernet Communication

ADDvantage-32 PLUS

8-8

ETHERNET. You will not be able to download Calibration and Configuration data to the drive

via ADDAPT 2000 over ETHERNET until these parameters are correctly set.

Obtain unused IP addresses from your MIS or IT department when setting up drives on a

network so the ID jumper may be set accordingly (or set ADDR LO to the available last octet).

If you are unsure if an IP Address is already used, use the “PING” command at a DOS prompt

on a PC connected on the network. The “PING” command can be used to test the

communication between the PC and another network device over the network. To invoke the

PING command, go to a DOS prompt and type “ping xxx.xxx.xxx.yyy”, where xxx.xxx.xxx is

the 1

three octets of the other device’s IP address and yyy is the number you picked. If you

receive Request Timeouts, there is nothing currently on the network using that address.

However, if the drives are connected to your company’s network, and you don’t obtain an

address from your MIS Department, there could be a device that is currently off that could be

turned on at a later time resulting in problems. The following illustrates a return following a

PING command:

C:\>ping 10.1.207.213

Pinging 10 1.207.213 with 32 bytes of data:

Reply from 10.1.207.213: bytes=32 time<10ms TTL=128

Ping statistics for 10.1.207.213:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milliseconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

“Request timed out” indicates the device is not present or not communicating.

“Destination host unreachable” indicates you are not on the correct network or are not

connected.

There are ESBX Ethernet configuration parameters contained in “DRIVE CALIBRATE”(X)

and “DRIVE CONFIGURE” (Y) menus of the ADDvantage-32 PLUS Drive. The parameter

numbers will vary depending on the ADDvantage-32 PLUS Application software being used

and will be noted below as “***”. Please reference Appendix C of your ADDvantage-32 PLUS

Drive manual that shows the parameter listing for your application software.

Drive Calibrate Menu – “X” Parameters

1 2 ... 359 360 361 362 363 364 365 366 367 368 369 ... 465 466

Sin comentarios

Digital Acoustics ESBx-110 Especificaciones Pagina 364