
Control Block Description
ADDvantage-32 PLUS
4-71
4.49 ONE SHOT
The block is used to initiate an action only once.
FIGURE 4-49. ONE SHOT BLOCK
1. Inputs
INP: Bit
2. Outputs
OUT: Bit
3. Implementation
If INP is low, then OUT is low.
When INP goes high, OUT will go high for only one execution time.
NOTE: The amount of time associated with a block execution can vary depending on the
application. Look up the input or output label in Appendix C of the manual for the
timing.
Comentarios a estos manuales