Digital Acoustics ESBx-110 Especificaciones Pagina 248

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 466
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 247
Control Block Description
ADDvantage-32 PLUS
4-118
******************************************************
W A R N I N G
If SPDVOL = high and no redundancy is selected (both RED and
V RED = low), then if a tach failure is detected in the primary tach,
the TL bit will turn on, and the output will not switch from the
failed tach. Similarly, if RED = high, but V RED = low, and if
both tachs fail, the TL bit will turn on and the output will not
switch but will remain dependent on the failed tach. In such a
situation, a tach failure could cause equipment to "run away" and
damage machinery or injure personnel. For this reason, any time
V RED = low and SPDVOL = high, Avtron HIGHLY
RECOMMENDS configuring one of the USR FAULTS (described
in Section III) to the TL output of the TACH SELECT block.
******************************************************
Any time a tach failure is detected, the TACH SELECT block will set appropriate output
bits, and switch speed feedback as the logic requires. The outputs will remain in their
states until the RES turns on. If the RES input is maintained in the high state, the TACH
SELECT block will not switch to any redundant modes, and tach failures will not be
detected.
SPECIAL NOTE:
The TACH SELECT block differs from the TACH SELECT-W block in how the GAIN
input is used to scale input feedback. The TACH SELECT block scales all inputs
(TACH1, TACH2, and CEMF) and compares the scaled inputs to the MXSPD input to
determine tach failures (i.e., tach fail is sensed if CEMF × GAIN > 0.2 × MXSPD and
TACH × GAIN< 0.05 × MXSPD). The TACH SELECT-W block compares the unscaled
inputs to MXSPD in determining tach failures (i.e., tach fail is sensed if CEMF > 0.2 ×
MXSPD and TACH < 0.05 × MXSPD). All other block operation and logic are identical.
Vista de pagina 247
1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 465 466

Comentarios a estos manuales

Sin comentarios