
Core Software Operation
ADDvantage-32 PLUS ● AC to DC Power Converter
3-5
D***:NOT USER 6
Y*** Parameters D*** Parameters
D***:IARM MIN PT
D***:IA MIN DELY
D***:SCR ENABLE
D***:IA SEAL
D***:REV_LOCKOUT
D***:ONE BIT
D***:ZERO BIT
3.6 DRIVE SEQUENCE RUNG DESCRIPTIONS
Figure 3-1 (on the following 15 pages) is a ladder logic diagram of the internal interlocks
for the core software. These rungs determine when specific features are enabled and
disabled. D*** parameters listed are values found in the digital data table. See Section II
and Appendix C for parameter explanations. Figure 3-1 applies only to AC to DC
Converter software part number 696xxx.
RUNG 1 Any fault that shuts down the drive picks up this fault bit. The bit seals itself in
until CLEAR FAULT goes high. There are eight user definable faults
available: Y:USR FAULT 1 through Y:USR FAULT 8
Figure 3-1. ADDvantage-32 PLUS Logic Diagram (sheet 1 of 14)
Comentarios a estos manuales