Digital Acoustics ESBx-110 Especificaciones descargar pdf (Pagina 368)

IEEE 802.3 Ethernet Communication

ADDvantage-32 PLUS

8-12

you are attempting to download to a failed Ethernet board whose failure symptom was a total

loss in communication, then the procedure below for downloading ESBX software to the board

will not work as communication with board is required. Avtron’s factory can program the

ESBX board without communication but it is not available for field use at this time.

The IP ADDRESS that should be entered into the ESBX ZAP program is the IP ADDRESS

that is set in the “DRIVE CALIBRATION” menu. The IP ADDRESS is not programmed into

the ESBX board; the ESBX board obtains its IP ADDRESS from the ADDvantage-32 PLUS

drive on which it is mounted. The reason the ESBX ZAP program needs the board’s IP

ADDRESS is because the programming data is sent to the board via ETHERNET and the IP

ADDRESS is the board address.

MAC or Media Access Control address is a unique value associated with a network adapter.

MAC addresses are also known as hardware addresses or physical addresses. The MAC

address remains fixed and follows the network device, but the IP address changes as the

network device moves from one network to another. TCP/IP protocol is a higher level and

requires the IP address.

ESBX Ethernet Board Firmware Download Instructions:

1. Record Target ADDvantage-32 PLUS drive information (Drive IP and Subnet mask

addresses). From the drive keypad, enter the “Drive Calibrate” menu and record the

following parameters: The “X” parameter numbers shown below are for drive

application software P/N 694012 V13. Please reference Appendix C of your

ADDvantage-32 PLUS Drive manual that shows the parameter listing for your specific

application software.

X090: IP ADDR HI __________________

X091: IP ADDR HM __________________

X092: IP ADDR LM __________________

X093: IP ADDR LO __________________

X094: MSK ADDR HI __________________

X095: MSK ADDR HM __________________

X096: MSK ADDR LM __________________

X097: MSK ADDR LO __________________

NOTE

Do not enter the number 256 for X093. Use the actual

DRIVE ID jumper settings on J8 as viewed for DRIVE

COM ID in the drive’s Diagnostic menu. If X093 does not

equal 256 then use the number in X093.

2. Record the ESBX board MAC Address, located on label of U1 of the ESBX board.

1 2 ... 363 364 365 366 367 368 369 370 371 372 373 ... 465 466

Sin comentarios

Digital Acoustics ESBx-110 Especificaciones Pagina 368